52
To validate the modified threshold, press the
OK
key.
To abort without saving, press the
key or turn the switch.
OK
002.00
k
Ω
Ω
Using the
key, move the cursor to the units.
002.00
k
Ω
Ω
Using the
keys, choose the unit of the alarm threshold you want to set:
W
or k
W
. Depending
on the function chosen, M
W
, mA, A, kA, and ms are also possible.
Using the
key, move the cursor to the value of the threshold.
Using the
keys, modify the selected digit. Then move the cursor to the next digit to
modify it, and so on.
0
02.00
k
Ω
Ω
0
4
2.00
k
Ω
Ω
If the alarm is not active, press the
key to activate it.
3.14. ADJUSTMENT OF THE ALARM THRESHOLD
The device makes an audible signal and the indicator flashes:
in continuity, resistance and insulation measurement, if the measurement is below threshold;
for earth and loop measurement, if the measurement is above threshold;
for short-circuit current measurements, if the measurement is below threshold;
in test of residual current device, if the measurement is not between the two thresholds (Tmin and Tmax).
In continuity measurement, the audible signal is used to validate the measurement.
In all the others functions, it reports an error.
The alarm threshold is adjusted in essentially the same way for all measurements.
Start by entering the alarm function by pressing the
or
key.
