3.12 TEMPERATURE MEASUREMENT
3.12.1 Measurement without external sensor
1.
Set the switch to
;
The temperature displayed (blinking) is the internal temperature of the device,
equal to the ambient temperature after a sufficiently long thermal stabilization time
(at least one hour).
3.12.2 Measurement with external sensor
The device measures the temperature using a K thermocouple.
1.
Connect the K thermocouple to the + and COM input terminals of the
device.
2.
Set the switch to
.
3.
Place the K thermocouple on the element or zone to be measured,
which must not be at a dangerous voltage.
The temperature is displayed on the screen.
To change the unit,, °F or °C, press the
key.
Remarks :
-
If the external sensor is defective, the temperature displayed blinks.
-
If there are large variations of the environment of the device, the
measurement must be preceded by a stabilization time.
Summary of Contents for CA-F201
Page 1: ...F201 Clamp multimeter GB User s manual...
Page 36: ...692882A02 Ed 7 07 2016...
