32
3.10.2 Balanced three-phase power measurement
1.
Set the switch to
;
2.
Press the yellow
key until the
symbol is displayed.
3.
The device automatically displays AC+DC. To select AC, DC, or
AC+DC, press the yellow
key until the desired choice is reached.
4.
Connect the black lead to the
COM
terminal and the red lead to "
+
";
5.
Connect the leads and the clamp to the circuit as follows:
If the red lead is connected…
…and the black lead is
connected
…then the clamp is on
the conductor
To the L1 phase
to the L2 phase
of the L3 phase
To the L2 phase
to the L3 phase
of the L1 phase
To the L3 phase
to the L1 phase
of the L2 phase
Reminder :
the arrow on the jaws of the clamp (see the diagram below) must point
in the presumed direction of flow of the current from the source (producer) to the
load (consumer)
Summary of Contents for F407
Page 1: ...F407 Clamp multimeter GB User s manual...
Page 50: ...50 Validate by choosing Close...
Page 53: ...53 3 5 Graph mode enlarged zoomed...
Page 74: ...693111A02 Ed 7 09 2016...
