GREEN TEST-FTV 100
English
Page 39 sur 47
12. TECHNICAL CHARACTERISTICS OF THE
"BLUETOOTH" COMMUNICATION KIT
The Bluetooth kit is used to transmit the atmospheric parameters from the remoted module to the GREEN
TEST FTV 100 instrument when the panels are placed at a distance from the inverter.
I/O INTERFACE
Master unit and slave unit, already programmed, RS232 ports for the real-time
communication interface with the GREEN TEST FTV 100
POWER SUPPLY
by RS232 or mains adapter 230V
AC
(5…7,5V)
POWER SUPPLY FOR
THE BLUETOOTH
SIGNAL
The minimum power supply provided by the remoted module for
communication between Bluetooth adapters is approximately 4.6V,
roughly equivalent to the low charge level of the battery (slow flashing of
the red indicator on the remoted module).
REMARK: in this case, we advise immediately replacing or recharging the
batteries.
TRANSMISSION
Bluetooth v2.0 + EDR
FREQUENCY
2.4…2.4835GHz, ISM licence
SPECTRUM
FHSS
RF OUTPUT POWER
Class 1
DISTANCE
100m - in free field
OPERATING
TEMPERATURE
from 0°C to +60°C.
USE
In zones protected from water and rain
MAXIMUM ALTITUDE
OF OPERATION
2000m
RELATIVE HUMIDITY
90% up to 40°C
STORAGE
TEMPERATURE
from -10°C to +70°C.
DIMENSIONS
76
x
62
x
20mm
MASS
approximately 50g
Other characteristics according to the manufacturer's manual provided
The optional Bluetooth adapters are of the highest quality, with the best characteristics and
performance available on the market.
Even so, some situations may induce perturbations and interfere with communication.
In these situations, we suggest moving the Bluetooth adapter (connected to the instrument by a
cable of sufficient length fitted with the two male/male RS232 connectors supplied with the remoted
module).
