16
LED & Colour Description
Yellow LED
embedded in
the connector
Ethernet
LED OFF: The stack failed to initialize or the Ethernet controller failed to initialize
Slow blinking (once a second): The stack initialized properly
Rapid blinking (10 times per second): The Ethernet controller initialized properly
Blinks twice, then pause: DHCP Error
LED ON: Network initialized and ready for use
Table 4
2.13. MEMORY CARD
The PEL accepts SD, SDHC and SDXC cards, FAT32 formatted, up to a capacity of 32 GB.
The PEL is delivered with a formatted SD card. If you want to install a new SD card:
Open the elastomer cap marked
.
Press on the SD card in the device, then withdraw it.
Warning: do not withdraw the SD card if there is a recording session in progress
Check that the new SD card is not locked.
It is best to format the SD card using the PEL Transfer software; it can also be formatted by a PC.
Insert the new card and push it home.
Put the protective elastomer cap back in place.
LOCK
Summary of Contents for pel 102
