32
4.2.
USING EXTERNAL DATA LOGGERS (PEL 104)
The PEL can connect itself with up to four L452 Data Loggers. The connection is in Bluetooth. It is configured using the PEL
Transfer software.
The L452 Data Logger can be used:
to record DC voltages up to 10V,
to record DC currents from 4 to 20mA,
to count pulses,
to detect events on the On/Off inputs.
Once connected to the PEL, they transmit their data to it. They are then displayed in the real-time data and recorded with the
recordings.
For the use of the L452 Data Loggers, refer to their user manuals.
4.3. RECORDING
To start recording:
Check that there is in fact an SD card (not locked and not full) in the PEL.
Press the
Selection
key and hold it down. The
REC
,
(PEL104), and
(PEL104) indicators light in turn for
3 seconds each.
Release the
Selection
key while the
REC
indicator is lit. Recording starts and the
REC
indicator starts blinking twice
every 5 seconds.
To stop recording, proceed in exactly the same way. The
REC
indicator starts blinking once every 5 seconds.
It is possible to manage recording from PEL Transfer (see § 5).
4.4. MEASURED-VALUE DISPLAY MODES
The PEL has 4 display modes, represented by the icons at the bottom of the display unit. To change from one mode to the other,
use the
or
key.
Icon
Display mode
Instantaneous values display mode: voltage (V), current (I), active power (P), reactive power (Q), apparent power
(S), frequency (f), power factor (PF), tan
Φ
.
Power and energy display mode: active energy of the load (Wh), reactive energy of the load (Varh), apparent
energy of the load (VAh).
Current and voltage harmonics display mode.
Maximum values display mode: maximum aggregated values of the measurements and energy of the last
recording.
The displays are accessible as soon as the PEL is on, but the values are zero. As soon as there is a voltage or current on the
inputs, the values are updated.
Summary of Contents for pel 102
