English
Brief introduction
Observation and Adjustment of Infrared Image
1. Press and hold on the power switch key to turn on the camera.
2. Wait till the initialization and data loading completely.
3. Take off the cover of lens and point to the target;
4. Whirl the lens for focusing;
5. Press key “A” to auto-adjustment
Note: the noise from the camera when operating is normal.
Analysis of temperature measurement
1. After startup the camera, press the “menu (enter)” key to pop up the menu;
2. Press the direction key
（
«
» or «
»
）
to enter the “Analysis”
3. Press the direction key
（
«
◄
» or «
►
»
）
to select “Spot 1”;
4. Press the menu (enter) key again;
5. Move the camera or move the cursor through the direction key to point to the
target;
6. The value displaying on the right-up corner is the target’s temperature;
7. Multi-spot measurement is available when selecting “Spot 2” and “Spot 3”
Note: you will only be able to move cursor 1 if “SP1” is written on the status bar
( It is the same thing for SPOT2 and SPOT3)
Store the infrared image
Solution 1 :
You can hold the key “S” for 2-3 seconds to store the image.
Solution 2 :
1. After startup the camera, press the « menu (enter) » key to pop up the menu ;
2. Press the direction key
and
to enter the « FILE » ;
3. Select “Save” and press the “menu (enter)” key.
Recall the infrared image
1. After startup the camera, press the « menu (enter) » key to pop up the menu;
2. Press the direction key
and
to enter the « FILE », then press the “menu”
key to enter
3. Press the direction key
and
to “Open” and press “ENTER”
4. Choose your picture with
◄
►
key
To go directly to a specific picture without seeing all the thermograms, press on
and
key.
www.electronicaembajadores.com
