WARNING: If your gloves are operated with the connectors exposed, it is possible for the electronics to endure significant stresses if the connection is pushed or pulled. The connector cover protects the
connection; eliminating the potential for these stresses to occur and ensuring that the performance of your gloves is not accidentally compromised. To learn how to use the cover, follow the sequence of
illustrations in Figure 1 to 5.
Figure 1:
Hold the glove, gripping each
connector as shown
Figure 2:
Grab and pull the right side of
the cover to open the left side of the
cover
Figure 3:
Insert the left connector into
the cover
Figure 4:
Pull the left side of the cover
to open the right side, exposing the
connector head; make the connection
Figure 5:
Connection completed
INSTRUCTIONS FOR USE
Email: customerservice@ChavalUSA.com
Bainbridge Island, WA
Chaval Response-XRT Heated Gloves
with
ALPHA
HEAT™ and
ACTIVE
DRY™
For your safety and the safety of those around you, please read these use guidelines carefully before using your gloves. Failure to adhere to these guidelines can result in serious injury and loss of property.
Figure 1:
These are latching connectors located in
the cuff of your gloves and on the charger leads.
WARNING: You will be unable to disconnect the connectors before understanding how to operate them. Please carefully read these instructions. Trying to force the connectors apart without properly unlatching
can result in irreparable damage.
Figure 2:
To unlatch, press the tab/lever on the
male end with your thumb while pulling them
directly apart. Warning: Flexing or “wiggling” the
connectors to get them apart will damage them in
time. To maintain the health of the connectors,
pull them directly apart without flexing them.
HOW TO USE THE CONNECTOR COVER
HOW TO USE LATCHING CONNECTORS
Figure 3:
Inside the cuff of the right hand, the
tab/lever is on the backside of the connector
assembly. Press it using your index finger. Then
pull them directly apart.
CONNECTED
DISCONNECTED
MALE
FEMALE
