Product Using
ALPHAAIR 450 USER MANUAL
| 2021-03
P a g e | 11
4 Product Using
4.1
Advance Preparation
◼
Take out the equipment from the container before using. Install it on the corresponding
platform and connect all cables. Meanwhile, set up the base station at an open sky area.
Turn on the equipment after the base station start recording static.
◼
Before data collection, it is necessary to check the remaining capacity of Alpha_LAS and
Alpha_CAM memory cards. If the remaining capacity is less than 10% or does not meet
the demand of current collection capacity, the data in card should be deleted in advance.
4.2
Equipment Installation
◼
First, install the equipment on the platform and lock it with screws. Remember to remove
the camera protective cover.
◼
Connect both power supply cable and GPS feeder cable of equipment and start power on.
◼
Put the equipment at an open sky area and turn on LiDAR &remote controller. Check
whether the controller and equipment status are normal.