CHCNAV ALPHAUNI 900 USER MANUAL
| 2020-06
P a g e | 42
6.1.4.2
Laser settings
Before start project, user need to set the scan speed and laser PRR first, then the Step Angle
will be calculated automatically. The starting angle and the ending angle are 0 and 360 by
default. It is important to note that the starting angle need to lower than the ending angle.
6.1.4.3
Other settings (Generally no use)
▪
Usr cmd: Support input relative code to check system when has issues.
▪
Advanced settings: Enter password 123321 and the controller will enter the “Laser
Settings” interface.
6.1.5
Laser Settings
▪
Storage: The storage location of the raw laser data is inside the AlphaUni 900 equipment.
▪
Parameters: It indicates some synchronization parameters which no need to modify here.
