Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
VS
VS
VS
VS----MIDI
MIDI
MIDI
MIDI Installation
Installation
Installation
Installation Manual
Manual
Manual
Manual
8
88
8----434 /
434 /
434 /
434 / v. 2.00
v. 2.00
v. 2.00
v. 2.00
Copyright © 2022 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
12
12
12
12
f) Unsolder two blue wires from solder lug on EG board (fig. 2.4.4) and solder blue wire Nr. 4 (EG) of the signal
bunched cables to this lug.
g) Unsolder blue wire from solder lug on VCF board (fig. 2.4.5) and solder green wire Nr. 5 (VCF) of the signal
bunched cables to this lug.
h) Unsolder blue wire from solder lug on VCA board (fig. 2.4.6) and solder yellow wire Nr. 6 (VCA) of the signal
bunched cables to this lug.
i) The original blue wires (which related EG, VCF, VCA boards) can be fully removed. Or they can be retained in
the instrument, but it is necessary to insulate them in this case so that no short occurs in the instrument.
Fig. 2.4.6
Fig. 2.4.6
Fig. 2.4.6
Fig. 2.4.6
2.5
2.5
2.5
2.5 INTERFACE BOARD INSTALLATION
INTERFACE BOARD INSTALLATION
INTERFACE BOARD INSTALLATION
INTERFACE BOARD INSTALLATION
2.5.1
2.5.1
2.5.1
2.5.1 INTERFACE BOARD PLACEMENT
INTERFACE BOARD PLACEMENT
INTERFACE BOARD PLACEMENT
INTERFACE BOARD PLACEMENT
a) The interface board will be placed on left side of the rear panel of the instrument (fig. 2.5.1).
b) Cleanse the part of rear panel inside of the instrument for the interface board placement (fig. 2.5.1). Use a
chemical cleaner to remove all dirt and grease.
Fig. 2.5.1
Fig. 2.5.1
Fig. 2.5.1
Fig. 2.5.1
Fig. 2.5.2
Fig. 2.5.2
Fig. 2.5.2
Fig. 2.5.2
