CHD 8-427 Owner'S Manual Download

Page: 16 / 32

Korg Polysix MIDI Interface

P6----M

M Owner‘s

Owner‘s

Owner‘s Manual

Manual

8----427 / v. 1.00

427 / v. 1.00

No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.

5.1.2.1

5.1.2.1 STANDARD CONTROLLERS

STANDARD CONTROLLERS

CC #1 : Modulation

The CC #1 increases depth of VCF modulation by additional interface's LFO. Maximal depth of the modulation
(i.e. when value of the CC #1 is 127) adjusts the VCF LFO MODULATION WHEEL interface patch parameter (see
chapter 4.2.12).

CC #64 : Hold

The CC #64 works only for received MIDI Notes. It doesn't work with instrument's keyboard

The CC #64 works standard way: holds tone generators of the instrument (active) during the hold pedal is
pressed. Values from 64 to 127 are recognized as hold-on status, values from 0 to 63 as hold-off status.

CC #120 : All Sound O

CC #120 : All Sound Off (ASO)

ff (ASO)

The CC #120 works only for received MIDI Notes. It doesn't work with instrument's keyboard!

All active MIDI Notes are released immediately after reception of CC #120 (note that the value of the CC #120
must be always zero).

CC #121 : Reset All C

CC #121 : Reset All Controllers (RAC)

ontrollers (RAC)

Standardized MIDI CCs and Pitch Bend controller are set to their initial status after the CC #121 reception (note
that the value of the CC #121 must be always 0):

CC #1

CC #1 (Modulation)

off (value 0)

CC #64

CC #64 (Hold)

off (value 0)

Pitch Bend

middle position (value 4096)

CC #122 : Local Off / On

The CC #122 with value from 64 to 127 ("Local On") executes reset of the interface. It is equivalent to pressing
of the interface's Reset button or to the Reset common system MIDI command.

Values 0 to 63 of the CC #122 ("Local Off") are ignored.

CC #123 : All Notes Off (ANO)

The CC #123 works only for received MIDI Notes. It doesn't work with instrument's keyboard!

All active MIDI Notes are released immediately after reception of CC #123 (note that the value of the CC #123
must be always zero).

Fig. 13

Fig. 13 –

––

– Instrument remote control

Instrument remote control

5.1.2.2

5.1.2.2 CONTROLLERS FOR REMOTE CONTROL

CONTROLLERS FOR REMOTE CONTROL

CC #40 : Arpeggiator Section

CC #40 : Arpeggiator Section ---- Arpeggio

Arpeggio

Controls remotely the ARPEGGIO button on instrument panel (

①

fig. 13). Every time the CC #40 with value 64 to 127 is received, the
ARPEGGIO button is pressed. Values 0 to 63 of the CC #40 have no
function (they are ignored). The ARPEGGIO panel button remains fully
functional - the CC #40 and the button can be used simultaneously.

CC #41 : Key Assign Mode Section

CC #41 : Key Assign Mode Section ---- Hold

Hold

Controls remotely the HOLD button on instrument panel (

②

on fig. 13). Every time the CC #41 with value 64 to

127 is received, the HOLD button is pressed. Values 0 to 63 of the CC #41 have no function (they are ignored).

Use CC #41 for remote control of HOLD button if you want the HOLD function to be active for both instrument’s own keyboard and MIDI Notes.