Monitoring Performance (asg perf)
Check Point Maestro R80.20SP Administration Guide | 104
Parameter
Description
--delay
<
seconds
>
Temporarily changes the update interval for the current
asg perf
session.
Enter a delay value in seconds.Default delays is 10 seconds.
Notes:
n
The
-b <
SGM_IDs
>
and
-vs <
VS_IDs
>
parameters must be at the start of the command.
If both parameters are used,
-b <
SGM_IDs
>
must be first.
n
If your Security Group is not configured in VSX mode, the VSX related commands are not available.
They do not show when you run the
asg perf -h
command.
Below are some examples:
Example 1 - Summary without Parameters (asg perf)
[Expert@MyChassis-ch01-01:0]# gclish
[Global] MyChassis-ch01-01> asg perf
Thu May 21 08:17:24 IDT 2015
Aggregated statistics (IPv4 Only) of SGMs: chassis_active VSs: 0
+--------------------------------------------------------------+
|Performance Summary
|
+----------------------------------------------+---------------+
|Name
|Value
|
+----------------------------------------------+---------------+
|Throughput
|751.6 K
|
|Packet rate
|733
|
|Connection rate
|3
|
|Concurrent connections
|142
|
|Load average
|2%
|
|Acceleration load (avg/min/max)
|1%/0%/4%
|
|Instances load (avg/min/max)
|2%/0%/8%
|
|Memory usage
|10%
|
+----------------------------------------------+---------------+
* Instances / Acceleration Cores: 8 / 4
* Activated SWB: FW,IPS
[Global] MyChassis-ch01-01>
Notes:
n
By default, absolute values are shown.
n
Unless otherwise specified, the combined statistics for IPv4 and IPv6 are shown.
n
When no Security Appliances are specified, performance statistics are shown for the Active
Security Appliance only.
