Monitoring Performance (asg perf)
Check Point Maestro R80.20SP Administration Guide | 105
Example 2 - Performance Summary (asg perf -v)
The
-v
parameter adds a performance summary for each Security Appliance.
[Expert@MyChassis-ch01-01:0]# gclish
[Global] MyChassis-ch01-01> asg perf -vs all -v -vv cpu 24h
Tue Oct 22 07:23:37 IST 2013
Aggregated statistics (IPv4 and IPv6) of SGMs: chassis_active Virtual Systems: 0
+-------------------------------------------------------------------------+
|Performance Summary
|
+---------------------------------------------+-------------+-------------+
|Name
|Value
|IPv4%
|
+---------------------------------------------+-------------+-------------+
|Throughput
|10.2 K
|100%
|
|Packet rate
|11
|100%
|
|Connection rate
|0
|N/A
|
|Concurrent connections
|22
|100%
|
|Load average
|7%
|
|
|Acceleration load (avg/min/max)
|6%/6%/6%
|
|
|Instances load (avg/min/max)
|5%/4%/9%
|
|
|Memory usage
|55%
|
|
+---------------------------------------------+-------------+-------------+
+-------------------------------------------------------------------------+
|Per SGM Distribution Summary
|
+-----+-----------+--------+--------+--------+----------+----------+------+
|SGM
|Throughput |Packet
|Conn.
|Concu.
|Accel.
|Instances |Mem.
|
|ID
|
|Rate
|Rate
|Conn
|Cores%
|Cores%
|Usage%|
+-----+-----------+--------+--------+--------+----------+----------+------+
|1_01 |10.2 K
|11
|0
|22
|6/6/6
|5/4/9
|55%
|
+-----+-----------+--------+--------+--------+----------+----------+------+
|Total|10.2 K
|11
|0
|22
|6/6/6
|5/4/9
|55%
|
+-----+-----------+--------+--------+--------+----------+----------+------+
+-----------------------------------+
|Per VS CPU Usage Summary
|
+-----+---------+---------+---------+
|VS ID|Avg. Cpu%|Min. Cpu%|Max. Cpu%|
|
|
|(SGM id) |(SGM id) |
+-----+---------+---------+---------+
| 0
|2
|1
(1_02)|2
(1_01)|
| 1
|0
|0
(1_01)|0
(1_04)|
+-----+---------+---------+---------+
* CPU stats is aggregated over the last 24hrs
[Global] MyChassis-ch01-01>
Make sure that resource control monitoring is enabled on all Security Appliances.
To enable resource control monitoring, in the Expert mode run:
# g_fw vsx resctrl monitor enable
By default, absolute values are shown.
Notes:
n
Average, minimum and maximum values are calculated across all active Security Appliances.
n
The Security Appliance ID with the minimum and maximum value shows in brackets for each
Security Appliance.
n
Unless otherwise specified, the combined statistics for both IPv4 and IPv6 are shown.
n
When no Security Appliances are specified, performance statistics are shown for the active
Security Appliance only.
