Installing and Uninstalling a Hotfix on Maestro Security Appliances
Check Point Maestro R80.20SP Administration Guide | 194
Uninstalling a Hotfix Package
Important:
n
For the
CPUSE
instructions, see
n
This procedure applies to Security Groups in both Security Gateway and VSX
mode.
In VSX mode, you must run all the commands in the context of VS0.
n
This procedure keeps the current connections.
n
Do
not
uninstall the hotfix on all the Security Appliances in a specific Security
Group at the same time.
n
With this procedure, you uninstall the hotfix on half of the Security Appliances at
one time.
The other half of the Security Appliances continues to handle traffic.
You divide all Security Appliances in a specific Security Group into two logical
groups - denoted below as "
A
" and "
B
".
1.
You uninstall the hotfix on the Security Appliances in the Logical Group
A
through a Security Appliance in the Logical Group
A
.
Connect to that Security Appliance over a serial console.
2.
You uninstall the hotfix on the Security Appliances in the Logical Group
B
through a Security Appliance in the Logical Group
B
.
Connect to that Security Appliance over a serial console.
