RMA of a Maestro Hyperscale Orchestrator
Check Point Maestro R80.20SP Administration Guide | 216
RMA of a Maestro Hyperscale Orchestrator
Follow the steps below to replace a failed Maestro Hyperscale Orchestrator in a setup of two Maestro
Hyperscale Orchestrators.
Note
- In the procedure below, we replace the failed Maestro Hyperscale Orchestrator
1_2
.
Step
Action
Instructions
1
On the working Maestro Hyperscale Orchestrator
1_1, backup the current configuration.
1.
Collect the Gaia Backup
2.
Back up these files:
n
/etc/sgdb.json
n
/etc/maestro.json
n
/etc/maestro_
remote.json
2
On the working Maestro Hyperscale
Orchestrator 1_1, bring down the
Synchronization interface.
By default, the Synchronization interface is:
n
On MHO-170, interface 1/32/1
n
On MHO-140, interface 1/48/1
To verify, run this command in Gaia Clish:
n
On MHO-170:
> show maestro port 1/32/1
type
n
On MHO-140:
> show maestro port 1/48/1
type
Example output from MHO-170:
Port 1/32/1 type is ssm_sync
n
On MHO-170, run these
commands in Gaia Clish:
> set maestro port
1/32/1 admin-state
down
> show maestro port
1/32/1 admin-state
n
On MHO-140, run these
commands in Gaia Clish:
> set maestro port
1/48/1 admin-state
down
> show maestro port
1/48/1 admin-state
