Working with the Distribution Mode
Check Point Maestro R80.20SP Administration Guide | 60
Configuring the Interface Distribution Mode (set distribution
interface)
Description
Use these commands to:
n
Set the interface Distribution Mode - For an interface when the system is not working in the General
Mode
n
Show the interface Distribution Mode - If it is assigned by Auto-Topology, or is manually configured
Notes:
n
You must run these commands in the Gaia gClish of the Security Group.
n
In VSX mode, you must go to the context of the applicable Virtual System before you can change the
interface Distribution Mode. Run the
set virtual-system <
VS_ID
>
command.
Syntax to set the interface Distribution Mode
> set distribution interface <
if_name
> configuration {user | network |
policy}
Syntax to show the interface Distribution Mode
> show distribution interface <
if_name
> configuration
Parameters
Parameter
Description
<if_
name>
Interface name as assigned by the operating system.
user
Manually assign the User (Internal) Distribution Mode - based on Destination IP
address.
network
Manually assign the Network (External) Distribution Mode - based on Source IP
address.
policy
Use Auto-Topology to automatically assign the Distribution Mode according to the
policy.
