Monitoring Management Interfaces Link State
Check Point Maestro R80.20SP Administration Guide | 95
Monitoring Management Interfaces Link State
By default, Security Group monitors the link state only on data ports
(ethX-YZ)
. The Management
Monitor feature lets SNMP monitor management ports on the Maestro Hyperscale Orchestrators. The link
state is sent to all Security Appliances.
The Management Monitor feature is disabled by default.
To enable this feature, run the
set chassis high-availability mgmt-monitoring on
command in Gaia gClish of the Security Group.
When the Management Monitor feature is enabled:
n
The monitored management ports are included in the Chassis grade mechanism, according to
predefined factors (default is 11).
n
The output of the
asg stat -v
command shows the Management ports.
See the
Chassis Parameters > Ports > Mgmt
line in the output example below.
n
The
show interfaces
command shows the link state of management interfaces based on this
feature mechanism.
