Page 15
3.3
Inserting batteries
1. Remove the rubber protection
cover.
»
Humimeter SLW with probe:
Remove the rubber protection
from the top of the housing (fig-
ure
and
).
»
Humimeter SLW with Hand electrode holder:
Disconnect it (see
"4.3.2 Disconnecting the hand elec-
) before you pull the rubber protection off
the bottom of the housing.
»
If your device is provided with an optional USB port,
remove the protection cap of the USB socket before.
2. Take hold of the device with one hand, press your thumb
onto the engraved area of the battery compartment (1)
and drag downwards (2) (figure
3. Insert the batteries with negative and positive terminals
matching those indicated on the battery compartment.
Press down the batteries so that they lay flat on the bot-
tom of the housing (figure
).
»
As soon as all batteries have been inserted, the device
switches on automatically.
4. Slide the battery cover onto the housing until it clicks into
place (figure
). Then mount the rubber protection cover onto the housing.
»
Humimeter SLW with probe:
start with the side on which the battery cover is.
»
Humimeter SLW with Hand electrode holder:
start with the side on which the sensor plug is positioned..
1
2
3
4
5
