3.0 GETTING STARTED
Cheetah Xi Programming Manual
3-9
P/N: 06-651
Rev 1, 09/2013
The IR Tool, as shown in Exhibit 3-13, has many uses with the Cheetah Xi addressable devices. Consult the
individual Installation and Maintenance Instructions (P/N 55-051) for a complete description of its operation.
To address a device using the IR Tool:
1. Press the PWR key on the IR tool. The main menu will be displayed.
2. Aim the IR tool at the device to be addressed and press the SELECT key. The device must be selected
before communication is enabled. When a device is selected, the LED on the device will change to a
blinking green pattern.
L
Note:
There must be a clear line of sight between the IR tool and the device it is communicating with.
3. The display will indicate ‘1. WRITE LOOP/ADR’. Press the ENTER key.
4. Use the number buttons to type in the desired Loop and Address number for the device. (Loops = 001-
004; Addresses = 001-254)
5. Point the IR tool at the device being addressed and press the ENTER key. If the address is accepted,
the display will indicate ‘OK NEW – Addr. SET.
6. If addressing devices sequentially, press the
×
key to increment to the next address number.
7. Press the SELECT button to select the next device.
8. Press ENTER to save the incremented address to the selected device.
1
3
2
4
5
6
7
8
9
0
PWR
SELECT KEY
SCROLL UP KEY
ESCAPE KEY
DESELECT KEY
SCROLL DOWN KEY
ENTER KEY
POWER BUTTON
Exhibit 3-13: IR Communication Tool
Summary of Contents for 10-068
Page 111: ......
