4.0 CONFIGURATION MENU
4-18
Cheetah Xi Programming Manual
Rev 1, 09/2013
P/N: 06-651
4.2.4.2
LEARN All devices
The Learn All Devices option erases the device supervision list stored in the Cheetah Xi controller and
creates a new supervision list by identifying all addressable devices connected to a signaling line circuit
(SLC). All device addresses, serial numbers, and device type information will be learned. The configurations
held by the devices will NOT be altered (nor will the custom messages).
From the “Learn” screen, press
+/-
keys to change to
Learn All Devices
as shown below; then press the Enter
key:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
S E L E C T
R E S E T
M O D E :
B
L E A R N
A L L
D E V I C E S
C
P R E S S
E N T E R T O
S T A R T
D
P A N E L
W I L L
R E S E T
Exhibit 4-26: LEARN ALL DEVICES Screen
The panel will reset and enter the Learn Mode:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
L E A R N M O D E
I S
A C T I V E
B
W A I T T O C O M P L E T E > >
C
0 9 : 2 7 : 4 7 A
0 3 / 1 0 / 2 0 0 9
D
A L : 0 0 0 S U : 0 0 0 T R : 0 0 0
Exhibit 4-27: LEARN Mode Active Screen
The display keypad is locked while learn mode is Active. Panel will display “LEARN MODE COMPLETE”
when process ends.
I
CAUTION
The Learn ALL method will delete and/or add supervision to
devices. Testing or review of the configuration should be
performed to ensure that all required devices are supervised.
Summary of Contents for 10-068
Page 111: ......
