ChefScape Chefscape L5747, Instruction Manual

5 

1.  Place the processing bowl on the motor base by lining up the handle on the 

processing bowl with the “Align Handle” position on the motor base. Turn the 
bowl clockwise to lock in place.  

Note:

  The processing bowl must be locked in 

place for the appliance to operate. 

2.  Insert the disc/blade support in the center of the processing bowl over the shaft.   

Be sure the disc/blade support is firmly in place and positioned all the way down 
on the shaft. 

3.  Select the desired blade or disc and slide over the disc blade support in the 

processing bowl.   

4.  Put the processor lid on the processing bowl, lining up the locking mechanism 

tab behind the processing bowl handle.  Turn the processing lid clockwise until 
the lid locks in place.  The food processor will not start until the processor lid is 
locked into position.  

CAUTION

:  Always wait until the blades have stopped 

turning before removing the processor lid and adding or removing food. 

5.  Plug cord into a 120-volt, AC electrical outlet 

ONLY

. 

6.  Turn the control dial to the desired speed. 

•

If the appliance is turned on but doesn’t start, make sure it is plugged in and the 
processing bowl and lid are properly locked in place.  The blue LED light ring will 
illuminate when this has been assembled correctly.  If the blades will not spin, 
unplug the appliance and reassemble the food processor following all of the 
assembly steps.  

CAUTION:

  Always unplug the appliance from the electrical 

outlet before placing hands in the processing bowl. 

•

For pulse-chopping, turn the control dial to “ON” and repeatedly press and 
release the “PULSE” button until the ingredients reach the desired consistency.  

Note:

  For best results, allow enough time between pulses for the food to fall to 

the bottom of the processing bowl.