the small wires leading from the movement to the battery holder.
2.
2.
2.
2.
Battery Installation
Battery Installation
Battery Installation
Battery Installation
a.
Remove the dial and attached movement from case.
b.
Insert batteries in battery compartment observing correct polarity (i.e. (+)
plus, (-) minus). The end of the battery compartment with the spring is the
negative end. Insert the negative end first.
3.
3.
3.
3.
Setting Time
Setting Time
Setting Time
Setting Time
a.
Remove one battery from the battery compartment.
b.
Set hands a few minutes ahead of actual time using the setting knob on the
back of the movement or by manually adjusting the minute hand (do not
touch the hour hand).
c.
When the set time coincides with actual time, insert battery back in battery
holder. The correct striking will start after 4:00, 8:00, or 12:00 o’clock. If
correct striking does not resume, remove one battery for a short time and
reset the time.
4.
4.
4.
4.
Start/Stop Strike
Start/Stop Strike
Start/Stop Strike
Start/Stop Strike
The switch for activating the strike mechanism is located in the lower right
corner of the back of the movement. Strike can be activated by moving the
switch to the B, or inactivated by moving the switch to the O.
PLEASE NOTE: Changing the batteries, switching the strike on, rapid adjustment
of the hands, or any diligent shaking of the clock may result in a random striking
sequence. However, the striking sequence will be correct after either 4:00, 8:00,
or 12;00 o’clock. IT IS AN INHERENT FEATURE OF THIS CLOCK THAT THE
STRIKING MAY OCCUR UPTO 30 SECONDS BEFORE OR AFTER THE
PRECISE TIME.
5.
5.
5.
5.
Loudness Control
Loudness Control
Loudness Control
Loudness Control
The loudness of the strike can be adjusted using the knob located in the upper
right corner of the back of the movement. Turning the
knob to the left increases the loudness; turning the knob to
the right decreases the loudness. The volume can be
reduced 50% for the next eight hours by moving the switch
in the lower left corner of the back of the movement to the
moon symbol. Moving the switch to the sun symbol returns
the volume to high.
6.
6.
6.
6.
Regulation
Regulation
Regulation
Regulation
Your clock was timed and regulated to within 3 seconds per
week. There can be no further regulation.
QUARTZ
QUARTZ
QUARTZ
QUARTZ –––– NON
NON
NON
NON----STRIKING:
STRIKING:
STRIKING:
STRIKING:
Your Quartz clock is powered by an alkaline-type battery adequate to operate the unit
for an average period of 20 months. However, it is recommended that the battery by
replaced every 12 months.
1.
1.
1.
1.
Start/Stop
Start/Stop
Start/Stop
Start/Stop
