Chapter 5. Software/Driver Configuration and Fine-tuning
Chelsio Network Driver for macOS
20
5.5.
Firmware Update
The minimum firmware version matching the driver must be loaded before the new driver installed
can load, and the loading is initiated by the post-install phase of the installer.
The current driver can load the new firmware using the
loadfw
command of
cxgbtool
that came
with the currently installed driver. Follow the steps mentioned below:
i. If not done already, mount the new disk image
cxgb-x.y.z
file by double-clicking on it. The
cxgb
disk image
should mount as a new device and place you in the base directory of the
cxgb
device.
ii. Browse to the
firmware
directory. For example, if the disk image was mounted to
/Volumes,
run the following commands to load the appropriate firmware based on Chelsio adapter family:
host:root# cd /Volumes/cxgb-x.y.z/firmware
host:root# sudo cxgbtool cxgbX loadfw <firmware-file>.bin
Summary of Contents for Terminator N310E
Page 1: ......