C
OLLOID
M
ILL
I. O. & M
16
8. Invert mill housing and wipe all exposed surfaces to remove any dust,
particulate or grease that may have accumulated.
9. Install Seal Plate
a.
Lip Seal Configuration
i. Press two lip seals into the seal plate with the lips facing
up until top lip is flush with th e raised, wetted face of the
seal plate.
ii. Slide seal plate down over shaft (
It may be necessary to
lubricate the sealing surface with mineral oil for ease of
installation.
).
iii. Replace seal plate o-ring around OD of plate in groove
provided. Do not st retch the o-ring to fit the oute r edge
of the seal plate, merely la y it on the out er most section
of the seal plate face.
iv. Secure plate in place w
ith the three locking screws
provided.
b.
Mechanical Seal Configuration
i. Press the stationary seal face into the seal plate.
ii. Slide seal plate down over shaft
iii. Replace the seal plate o-ring around OD of plate in
groove provided.
iv. Secure in place with the three locking screws provided.
v. Install the rem aining mechanical seal com ponents in
accordance with standard protocol.
10. Install rotor by threading it onto the shaft.
11. Stator
a. If stator or stator o-ring has b een replaced, the stator must be
pressed back into position within the stator housing.
