Operations 20
To update the current firmware installed in your server, from the BMC menu bar, click
Maintenance > Firmware Update
.
This wizard takes you through the process of updating the firmware. A reset of the server will
automatically follow if the upgrade is completed or cancelled. An option to Preserve All
Configuration is available. Enable it, if you wish to preserve configured settings through the
upgrade.
WARNING:
After entering update mode widgets, other web pages and services will not work.
All open widgets will be closed automatically. If upgrade process is cancelled in the middle of
the wizard, the device will be reset.
AVERTISSEMENT:
Une fois dans les widgets en mode de mise à jour, les autres pages Web
et services ne fonctionneront pas. Tous les widgets ouverts seront fermés automatiquement.
Si le processus de mise à niveau est annulé au milieu des procédures de l'assistant, le
périphérique sera réinitialisé.
NOTE:
The firmware upgrade process is a crucial operation. Make sure that the chances of
a power or connectivity loss are minimal when performing this operation.
Once you enter into Update Mode and choose to cancel the firmware flash operation, the
BMC must be reset. This means that you must close the Internet browser and log back onto
the BMC before you can perform any other types of operations.
Once Firmware upgrade using web is started, the regular IPMI command will not be allowed
for safety concern if Enable IPMI Command handling during flashing support is disabled in
project configuration.
