RB13804N4WFT
System
Components Removal and Installation
│
21
Figure 14
3.5”
HDD removal (tool-less type)
1.
Loosen a screw as shown and bottom up the HDD tray, and place the HDD tray as shown.
2.
Press your two thumbs on the HDD as shown.
NOTE:
Please operate this on a stable surface in case the HDD dropping unexpectedly.
3.
Lift the narrower side with your other fingers and release the HDD.
Figure 15
3.5”
HDD installation (tool-less type)
1.
Slide in the HDD until align the anchor point of HDD tray.
2.
Push down the HDD when it is locked into place.
NOTE:
Due to degraded performance and reliability concerns, the use of the 3.5” drive blank as a 2.5” device bracket is intended
to support SSD type storage devices only. Installing a 2.5” hard disk drive into the 3.5” drive tray cannot be supported.
