26
Through the Gateway, you can set up various smart scenarios according to your habits
and needs, programming the operations of smart devices and the interactions between
them. From the main screen (fig. 33), you can get to the Smart management screen (fig.
34), from which you can set Scenes, schedule devices to turn on and off and set rules for
interaction between devices.
Switch off the Gateway.
Switch on the Gateway by pressing and holding the button on the bottom of the
Gateway. Release the button two seconds after the bright YELLOW LED comes on. After
approximately one minute, the status LED starts flashing RED-GREEN-BLUE rapidly,
indicating that the reset/upgrade procedure is in progress. Once the update is complete,
the Gateway will restart.
Switch off the Gateway.
Connect the USB stick containing the update file provided by the manufacturer and
restart the Gateway by pressing the power button.
The LED will start flashing GREEN-RED as soon as the Gateway detects the update
file on the USB stick. To proceed with the update, leave the USB stick inserted in the
Gateway. Otherwise, remove it within 10 seconds. If you proceed with the update, the
Gateway will reboot, at which point the YELLOW LED will first come on again, and after
a few moments, the fast flashing RED-GREEN-BLUE will begin. Do not remove the USB
stick during this step.
The Gateway will restart after the update, which may take several minutes (status LED
YELLOW). At this point, remove the USB stick to allow the Gateway to boot up normally
and avoid repeating the update.
SMART MANAGEMENT
FACTORY RESET
USB UPDATE PROCEDURE
Fig. 33
Fig. 34
E
NG
L
IS
H
Summary of Contents for METAHome
Page 2: ......