Chery QQ Service Manual 465 Engine Mechanical System
- 28 –
Chery Automobile Co., Ltd
Chapter 7 Replacement of Timing Belt
Install timing belt according to following
order
：
1) Connect the tensioner assembly to
torsion spring to the pump(in front of rear
cover),fasten the bolts and nuts until the
tensioner assembly is easy for you to move.
Notice: You should make sure that every
screw and nut is loosened during the
process of above-mentioned work, for the
purpose of camshaft and pulley can rotate
freely.
2) There are a dot on radial line mark
of camshaft timing belt pulley and another
dot on belt rear cover. Run belt pulley to
align dot and dot .
3) There is a dot on belt rear cover. Run
crankshaft to align dot and dot .
4) Two timing belt pulleys are aligned with
each other. Under the circumstances of belt
being tightened, install the timing belt
according to the illustration of
5) After installation of belt, put up one end
of torsion spring on the tension bracket, put
up the other end of torsion spring on water
pump screw, the spring tune-up the belt
through self own tension, adjust the bolts
and screws to regulated value.
Turn crankshaft two circles clockwise and
adjust the tensioner bolts and screws to the
Tensioner bolt
tighten torque
14.71
～
22.56N·m
(1.5
～
2.3kg·m)
