Chery QQ Service Manual 465 Engine Mechanical System
- 33 –
Chery Automobile Co., Ltd
Side clearance
Use thickness gauge, make sure the side
clearance, in accordance with data between
thickness gauge and gear, shown as blow:
limit
:
0.17mm
III Installation of oil pump
Parts of disassemble should be cleaned,
you should satisfy the following requests
when installing the oil pump:
1) There is a dot mark on the outside
wheel gear. The dot mark should face
outwards when installing the outside wheel
gear to the pump body. Shown as blow:
2) You should use new sealing gasket when
installing the oil pump to the crankcase.
You should smear the HZ-1213 oilproof
silicon fluid sealant . The surface should be
cleaned before you smear.
Notice: You should lubricate the oil seal
mouth before installation.
IV Procedures of installation
1 Install oil pump and tighten bolt
2 Install oil pump suck oil pipe and make it
fastened.
3 Install oil pan and oil drain plug
4 Install exhaust pipe
5 Install oil pressure switch and tighten it.
6 Install timing belt rear cover
7 Install crankshaft timing gear
8 Install camshaft timing gear according to
the illustration.
Attention: Align the oil level, fill SAE 10
W 30 oil in the engine.