Chery QQ Service Manual 465 Engine Mechanical System
- 29 –
Chery Automobile Co., Ltd
2 Remove intake hose of thermostat
cover
3 Remove intake hose of radiator
4 Remove intake hose
procedures of installation
1 Install the intake hose to the right position
aligning the hose mark.
2 Connect intake hose and radiator
3 Connect intake hose and thermostat cover
4 Refill coolant, see the illustrations.
III Replacement of bottom radiator pipe
procedures of disassemble
1 Empty the cooling system, see the
illustrations.
2 Remove vent hose from engine cooling
manifold
3 Remove vent hose of radiator
4 Remove vent hose
procedures of installation
1 Install the bottom radiator pipe properly,
aligning the hose mark.
2 Connect vent hose to the radiator.
3 Connect vent hose and engine cooling
manifold
4 Refill the cooling system, see the
illustrations.
IV Replacement of cooling fan
procedures of disassemble
Caution: Electric fan of engine cover will
rotate , injure you and other people even if
the engine is not working, you should be far
away from the electric fan of engine cover.
Caution: To avoid casualty or vehicle
damage, you should replace the fan board
or outer cover if they are broken or
damaged.
1 Disconnect the power supply cooling fan.
2 Remove fan cover construction bolt from
radiator.
3 Remove engine cooling fan.
procedures of installation
1 Install cooling fan
Notice: See cautions and relevant remarks
concerning fastener.
2 Install fan erection bolt
Fasten the nut to: 3.5-4.5 N.m
3 Connect cooling fan power
4 Check to see whether or not fan motor
works normally.