Handrail Length & End Brackets
Please Note;
The bottom newel adjustable End Bracket (AXEVEBC) is a three part
assembly, consisting of a newel connector, a handrail connector and a
handrail cap, with various fixing screws, bolts and washers. It must be
fitted with the angles in the same orientation as the rake of the stairs.
The following is a job best done by two people. First you must fit the
newel connector onto the top of the bottom newel and secure by pre
drilling and using the two 30mm screws provided, remembering to
align the connector with the handrail (fig. 5)
Now fit the top newel Round Handrail Connector (AXEVHR) to the
handrail. Slide the connector onto the handrail and secure using the
two 30mm screws provided. Now loosly assemble the remaining half
of the bracket, using the bolt and two washers provided (fig. 6).
Then with a pre-assembled spindle (
instructions found
on the following pages
) secured onto the baserail no
more than 99mm away from the newel, lay the handrail
assembly onto the spindle to determine the height of
where the bracket sits on the newel. Secure using two
30mm screws provided (fig. 7)
Next slide the handrail connector onto & up the handrail
until it drops into the newel connector and the bolt hole
is perfectly aligned, you can now pre drill and secure the
handrail connector in its position using the three 25mm
screws provided. Then loosely fix the handrail connector
axxys
®
evolution
fitting instructions
