Safety
-
Installation should be performed only by a qualified electrician.
-
Disconnect power at the source before installation, inspection or removal.
-
Do not use the BLC200 if it is damaged.
-
The electrical installation must be in conformance with the national legislation and relevant
standards.
-
The mains connection of the BLC200 must be provided with a fuse or circuit breaker.
-
The BLC200 has protection class IP20 and is suitable for use at indoor locations. Mount the
-
BLC200 in an IP66 housing for use at outdoor locations.
BLC 200
Mymesh Building Light Control
The Mymesh BLC200 is a product in the Mymesh Building Light Control product suite for
wireless lighting control. The BLC200 is a wireless light controller for DALI and 1..10V drivers. A
relay is available to control the power to the driver and lighting fixture.
Application
-
Refer to the BLC200 product sheet (see chess-wise.eu/downloads) for the maximum
ratings of the relay and the environmental conditions.
Installation
-
Mount the BLC200 with 2x M4 screw/bolt (140mm distance).
-
Use maximal 1.5 mm2 wiring for all connections. Push the wires completely into the terminal
-
block. Use wire end sleeves when using flexible wires.
-
De BLC200 can be wired in three configurations: DALI driver, 1..10V driver or a 230V load. See
-
wiring diagrams below.
-
Use either 1..10V or DALI, not both.
-
Do not connect more than one DALI driver to a BLC200.
by Chess
