1.0 05/05/2013
8
correct.
15
．
Care should be taken to ensure that the locking screw must be tightened.
16
．
When the preparatory work has not been finished, do not hurry up for operation.
17
．
Without the right tools, or not equipped with the right tools in the workshop, do not use
alternative tools.
18
．
When the lathe is in its energized state, it is not allowed to remove the protective plate
or to open the door.
19
．
There shall be no hands or bodies moving within the working area of the moving parts.
Attention should be paid that there may be machine parts dropping. Pay attention that, when
moving the hands and bodies, keep a relative position of them with the lathe. Pay attention to
the tool gripped in your hand or the other part that has been
inserted into the chuck or the workpiece. Pay attention that do not place your hand or the other
part of your body on a position, where your hand or the other part of your body may get hurt by
the chuck or the workpiece.
20
．
Care should be taken not to cause an accident due to toggle the handle, to manipulate
the clutch or to switch on the power.
21
．
Master each function and various methods of operation.
22
．
Never put your hand on the chuck or the workpiece to stop the rotation of the spindle.
23
．
For the lathe driven through the clutch, when the clutch is in the disengaged state, the
spindle should stop its rotation, or otherwise the clutch or the brake device should be adjusted.
24
．
When the machine tool is not used, ensure that the power of the machine tool should
be switched off.
25
．
Before changing a new workpiece, it is necessary to stop the rotation of the chuck.
26
．
Attention should be always paid to check the transmission of such transmission parts
as the chuck and the belt pulley to find out whether it is loose.
27
．
When the chuck wrench is in the chuck, do not start the spindle.
28
．
When not able to focus on your work, do not operate the machine tool, so as to prevent
from any accident.
29
．
When making preparations to carry out other aspects of the operation of the machine
tool, such as the tailstock, be careful that there shall be no such dangers as collision or falling
off occurred.
30
．
Care should be taken that the chuck shield and other protective covers of the machine
tool should be tight without looseness
31
．
Those keeping long hair should put on a helmet, when operating the machine tool, so
