5.
Remove the hex socket cap screws (D
and/or E, Fig18) depending on the which
gear is being changed.
6.
Install the new gear(s) and tighten into
place with a hex socket cap screw.
7.
Loosen the nut (B, Fig 18) and move the
quadrant back so that the teeth mesh on
the gears and tighten the nuts (A and B).
Caution:
Make sure that the is a backlash of
0.002” -0.003” between the gears, setting
the gears too tight will cause excessive noise and wear.
8.
Close the door and
connect the machine to the power source.
Automatic Feed Operation and Feed Changes
1.
Move the forward/reverse selector (A, Fig
19) up or down depending on the required
direction.
2.
Set the selectors (A, B, C and D, Fig 20) to
the desired rate.
Note:
for feeding, lever D will be set at “F” or
“D” depending on the desired feed rate.
Powered Carriage Travel
1.
Push the lever (D, Fig
19) to the left and down to engage the cross feed.
2.
Pull the lever to the
right and up to engage the longitudinal feed.
17
Summary of Contents for Voyager Lathe
