Warning!
1.
Read and understand the entire instruction manual before attempting to
assemble or operate the machine.
2.
This lathe has been designed and is intended to be used by trained and
experienced personnel only. If you are not familiar with the correct and safe
operation of a lathe, do not operate this machine until you have been properly
trained.
3.
Always wear approved safety glasses/face shields when using this machine.
4.
Make certain the machine has been properly grounded.
5.
Before operating the machine, remove ties, rings watches and other jewellery,
rollup sleeves above the elbows, remove loose clothing and confine long hair.
Do not wear gloves.
6.
Keep the floor around the machine clean and free from scrap material, oil and
grease.
7.
Keep the machine guards in place at all times when the machine is in use, if
they are removed for maintenance purposes, use extreme caution and replace
the guards immediately.
8.
Do not over reach, maintain a balanced stance at all times so that you do not
fall or lean against cutting tools or the moving parts.
9.
Make all machine adjustments or maintenance when the machine has been
unplugged from the power supply.
10.
Do not force a tool or attachment to do a job which it was not designed for.
11.
Replace any warning labels if they become damaged or obscured.
12.
Make sure that the power switch is in the off position before connecting the
machine to the power supply.
13.
Give your work your undivided attention at all times, looking around,
continuing a conversation and general “horse-play” are careless acts that can
result in serious injury.
14.
Keep visitors a safe distance from the work area.
15.
Use recommended accessories, using unsuitable accessories can be
hazardous.
16.
Make a habit of checking to see that keys and adjusting wrenches are
removed before turning the machine on.
17.
Never attempt any operation or adjustment if the procedure is not understood.
18.
Keep fingers away from any rotating parts and cutting tools while in operation.
19.
Keep the belt guard in place and in working order.
20.
Never force the cutting action.
21.
Do not attempt to adjust or remove tools during operation.
22.
Always use identical replacement parts when servicing the machine.
23.
Always use keep cutting tools sharp.
24.
Never operate or allow the machine to be operated by personnel under the
influence of alcohol or drugs.
25.
Failure to comply with the above warnings may cause serious injury.
2
Summary of Contents for Voyager Lathe
