Chevrolet/GMC Silverado 1500 / Sierra/Sierra Denali 1500 Owner Manual
(GMNA-Localizing-MidEast-16515122) - 2023 - CRC - 8/12/22
Infotainment System
167
Canceling Google Assistant
.
Press
c
on the steering wheel controls
to cancel the Google Assistant request.
Helpful Hints for Speaking Commands
Voice recognition identifies commands that
are naturally stated in sentence form,
or direct commands that state the
application and the task.
For best results:
.
Speak the command naturally, not too
fast, not too slow.
.
Use direct commands without a lot of
extra words. For example,
“
Call <name>
at work,
” “
Play
”
followed by the artist or
song name, or
“
Play
”
followed by the
radio station number.
Direct commands are more clearly
understood by the system. An example of a
direct command is
“
Dial <number>.
”
If a cell phone number was saved with a
name and a place, the direct command
should include both. For example
“
Call
<name> at work.
”
Voice Recognition for the Radio
When voice is started, the voice recognition
commands for AM, FM, and media apps (if
supported) are available.
“
Play <AM frequency> AM
”
:
Tune to the
radio station frequency identified in the
command (like
“
nine fifty
”
).
“
Play <FM frequency> FM
”
:
Tune to the
radio station frequency identified in the
command (like
“
one oh one point one
”
).
Voice Recognition for the Phone
Make sure the phone is paired using
Bluetooth to use the phone related voice
commands.
“
Call <contact name>
”
:
Initiate a call to a
stored contact. The command may include
location if the contact has location numbers
stored.
“
Call < phone number>
”
:
Initiate a call to a
phone number of seven digits or 10 digits.
“
Send a message to <contact name>
”
:
Send
a message to a stored contact.
Voice Recognition for Navigation
Navigation commands can be used to start,
cancel route, or add way points/POI.
“
Navigate to <destination address>
”
:
Initiate navigation to the address in the
command.
“
Add <destination> on my way
”
:
Adds a
way-point to the current route.
“
Take me home
”
:
Starts navigation to
Home location set in Google maps.
Onboard Vehicle Commands
These commands can be used to adjust
vehicle temperature, control window
defrosters and obtain fuel information.
“
Turn on the A/C
”
:
Turns on the air
conditioning.
“
How much gas do I have left
”
:
Find out
how much fuel your vehicle has left.
“
Set temperature to <desired number>
degrees
”
:
Set to a specific temperature
inside your vehicle.
Phone Assistant Voice Recognition
While a device is connected via Bluetooth,
press and hold
g
on the steering wheel
controls to pass through and launch Google
assistant on the phone or Siri.
