Chevrolet Suburban Heavy-Duty Package (GMNA-Localizing-U.S./Canada/
Mexico-9419415) - 2016 - CRC - 9/4/15
22
Vehicle Care
If the DIC message comes on with
no sign of steam, try this for a
minute or so:
1. In heavy traffic, let the engine
idle in N (Neutral) while
stopped. If it is safe to do so,
pull off the road, shift to
P (Park) or N (Neutral), and let
the engine idle.
2. Turn on the heater to full hot at
the highest fan speed and
open the window as necessary.
If the vehicle no longer has the
overheat warning, the vehicle can
be driven. Just to be safe, drive
slower for about 10 minutes. If the
warning does not come back on,
drive normally and have the cooling
system checked for proper fill and
function.
If the warning continues, pull over,
stop, and park the vehicle
right away.
If there is still no sign of steam and
the vehicle is equipped with an
engine driven cooling fan, push
down the accelerator until the
engine speed is about twice as fast
as normal idle speed for at least
five minutes while the vehicle is
parked. If the warning is still there,
turn off the engine and get everyone
out of the vehicle until it cools down.
The decision may be made not to lift
the hood, but to get service help
right away.
Power Steering Fluid
See
for reservoir location.
When to Check Power Steering
Fluid
It is not necessary to regularly
check power steering fluid unless
there is a leak suspected in the
system or an unusual noise is
heard. A fluid loss in this system
could indicate a problem. Have the
system inspected and repaired.
Wait for the power steering system
to cool, with the engine off, before
checking the fluid.
How to Check Power Steering
Fluid
To check the power steering fluid:
1. Turn the key off and let the
engine compartment
cool down.
2. Wipe the cap and the top of the
reservoir clean.
3. Unscrew the cap and wipe the
dipstick with a clean rag.
4. Replace the cap and
completely tighten it.
5. Remove the cap again and
look at the fluid level on the
dipstick.
The level should be between the
ADD and FULL marks. If necessary,
add only enough fluid to bring the
level up to the hashed area between
the ADD and FULL marks.