7-24 T R A N SM ISSIO N A N D CLUTCH
Fig. 1 N--Transmission Cross-Section
4. Using snap ring pliers, remove countershaft rear bear
ing retaining snap ring (fig.
6
N).
5.
Remove main drive gear bearing cap and main drive
gear (fig. 7N).
NOTE: Use caution so as not to drop mainshaft
spigot bearing rollers in transmission case.
6
.
Pry mainshaft assembly to rear of transmission case to
expose rear bearing. Remove snap ring from bearing,
using a suitable puller, remove rear bearing (fig.
8
N).
7. Raise front end of mainshaft to clear case, then remove
the mainshaft assembly.
Reverse Idler Gear Removal
1. Remove reverse idler lockscrew and lock.
2. Using a suitable puller remove reverse idler shaft (fig.
9N).
3. Remove reverse idler gear, bearings, and two thrust
washers from case (fig. ION).
Countershaft Removal
1. Pry countershaft to the rear to expose rear bearing and
remove snap ring from bearing.
CHEVROLET OVERHAUL M A N U A L SUPPLEMENT
Summary of Contents for 40 60 Series
Page 1: ...40 60 SERIES TRUCK SUPPLEMENT ST 334 72...
Page 86: ......
Page 96: ...n 47 k u m i i i iin I ll II I...
Page 222: ......
