A U TO M A TIC T R A N SM ISSIO N 7-69
ROLLER CLUTCH
ASSEMBLY
REACTION
CARRIER
SUN
GEAR
PLASTIC GEAR
RING
OUTPUT
CARRIER
Figure 3 6 — R e m o v in g R eaction C arrier an d
Roller Clutch from O utput Carrier
10. Remove output shaft to output carrier snap
ring (fig. 38).
11. Remove output shaft.
NOTE: If replacement of speedometer drive
gear is n ecessary, remove in following manner:
a. Remove snap ring from output shaft.
b. Install speedometer gear removing tool
Figure 3 8 — R em o vin g O utput Shaft to Carrier S n a p Ring
(J-21427-01) and 3 /8 ”-16 bolts with suitable puller
(J-9539), on output shaft and remove speedometer
drive gear (fig. 39).
c. Install new speedometer drive gear and
drive to location (5-43/64" below end of output
shaft) using J-5590 (fig. 40).
d. Install snap ring in groove nearest output
shaft flange.
12.
Remove output shaft to rear internal gear
thrust bearing and two (
2
) races.
Figure 3 7 — R em oving Sun G e a r
Figure 3 9 — R em o vin g S p eedom eter D rive G e a r
CHEVROLET OVERHAUL M A N U A L SUPPLEMENT
Summary of Contents for 40 60 Series
Page 1: ...40 60 SERIES TRUCK SUPPLEMENT ST 334 72...
Page 86: ......
Page 96: ...n 47 k u m i i i iin I ll II I...
Page 222: ......