A U TO M A TIC TR A N SM ISSIO N
7
-95
Figure 117— Installing Center Supp ort into Reaction
Carrier a n d Roller Clutch A sse m b ly
outer side (fig. 114).
18. Install roller clutch assem bly into reac
tion carrier outer race (fig. 115).
19. Install center support to reaction carrier
thrust washer into r e c e ss in center support. R e
tain with petrolatum (fig. 116).
20. Install center support into reaction car
rier and roller clutch assem bly (fig. 117).
NOTE: With reaction carrier held, center sup
port should only turn counterclockwise.
21. Install gear rem over (J-21795) (fig. 32),
on gear unit assem bly to hold units in place.
22. Install output shaft to case thrust washer
tabs in pockets (fig. 118).
ASSEMBLY OF UNITS INTO
TRANSM ISSIO N CASE
1. Install rear band so that two lugs index
with two anchor pins. Check to make sure band is
seated on lugs (fig. 119).
2. Install the center support-to-case spacer
against the shoulder at the bottom of case splines
and with the gap located adjacent to the band anchor
pin (fig.
120
).
Figure 119— Installing R ea r B an d
C AUTION: DO NOT confuse th is spacer
(0.040" th ic k and both sides fla t) w ith
e ith e r the ce n te r s u p p o rt-to -c a s e snap
rin g (one side is beveled) o r the in te r
m ediate clutch backing p la te -to -c a s e snap
rin g (0.093" th ic k and both sides fla t).
3. Install proper rear selective washer (proper
washer determined by previous end play check)
into slots provided inside rear of transm ission
case.
4. Install complete gear unit assem bly into
case, using tools J-21795. J-9539, and J-6585-2,
making sure center support bolt hole is properly
aligned with hole in case. Refer to figure 32.
5. Oil and install center support to case r e
taining snap ring with bevel side up (flat side against
center support) and locating gap adjacent to band
anchor pin. Make certain ring is properly seated
in case (fig.
121
).
6
. Install case to center support bolt by plac
ing the center support locating tool into the case
direct clutch passage, with the handle of the tool
CENTER SUPPORT
TO CASE SPACER
# LOCATE SPACER GAI
ADJACENT TO
>
’ BAND ANCHOR PIN
Figure 118— Installing Case to O u tp u t Shaft Thrust W asher
Figure 1 2 0 — Positioning Center Support to C o se S p a ce r
CHEVROLET O VERHAUL M A N U A L SUPPLEMENT
Summary of Contents for 40 60 Series
Page 1: ...40 60 SERIES TRUCK SUPPLEMENT ST 334 72...
Page 86: ......
Page 96: ...n 47 k u m i i i iin I ll II I...
Page 222: ......
