Black plate (3,1)
DURAMAX Diesel Engine (LML/LGH) - 2011
In Brief
1-3
To reset the Engine Oil Life System
on most pickup models:
1. Display the OIL LIFE
REMAINING on the DIC. If the
vehicle does not have DIC
buttons, the vehicle must be in
P (Park) to access this display.
2. Press and hold the SET/RESET
button on the DIC, or the trip
odometer reset stem if the
vehicle does not have DIC
buttons, for more than
five seconds. The oil life will
change to 100%.
On all models, the Engine Oil Life
System can be reset as follows:
1. Turn the ignition to ON/RUN with
the engine off
2. Fully press the accelerator
pedal slowly three times within
five seconds.
3. Display the OIL LIFE
REMAINING on the DIC.
If the display shows 100%,
the system is reset.
4. Turn the key to LOCK/OFF.
See
Engine Oil Life System on
page 10
‑
10
.
Diesel Particulate Filter
(Exhaust Filter)
The Duramax engine is equipped
with a Diesel Particulate Filter (DPF)
that, by design, will filter or trap
particulates. The DPF is located
under the vehicle in the exhaust
system and looks like a catalyst.
Depending on a number of factors
monitored by the engine computer,
the DPF will need to be cleaned
of accumulated solids. When a
cleaning is needed, the engine
computer will initiate a cleaning
action by warming the exhaust gas
temperature. This feature has been
designed to operate automatically,
with limited operator involvement or
awareness.
Cleaning the DPF (Exhaust
Filter)
While the DPF cleaning is
automatically controlled by the
engine computer, the vehicle will
need to operate continuously for
approximately 30 minutes and
at speeds greater than 48 km/h
(30 mph) to clean the DPF
effectively. If the vehicle is returned
to idle during the cleaning process,
the driver may notice a slightly
different sound or a slightly elevated
engine idle speed. This is normal.
No action is required on the part of
the driver during a regular DPF
cleaning. See
Diesel Particulate
Filter (Exhaust Filter) on page 9
‑
10
.