Chicago Electric 1624, Set Up And Operating Instructions Manual

SKU 1624 

for technical questions, please call 1-800-444-3353. 

Page 4

or other part that is damaged should 

be properly repaired or replaced.
DIRECTION OF FEED. Feed work 

20. 

into a blade or cutter against the 

direction of rotation of the blade or 

cutter only.
NEVER LEAVE TOOL RUNNING 

21. 

UNATTENDED. TURN POWER OFF. 

Don’t leave tool until it comes to a 

complete stop.

groundIng InstruCtIons

to preVent 

eleCtrIC sHoCk 

and deatH from 

InCorreCt groundIng 

wIre ConneCtIon 

read and follow tHese 

InstruCtIons:

110-120 V~ grounded tools: tools 

with three prong plugs

In the event of a malfunction or 

1. 

breakdown, grounding provides a 

path of least resistance for electric 

current to reduce the risk of electric 

shock. This tool is equipped with an 

electric cord having an equipment-

grounding conductor and a ground-

ing plug.  The plug must be plugged 

into a matching outlet that is properly 

installed and grounded in accordance 

with all local codes and ordinances.
Do not modify the plug provided – if it 

2. 

will not fit the outlet, have the proper 

outlet installed by a qualified electri

-

cian.
Improper connection of the equip-

3. 

ment-grounding conductor can re-

sult in a risk of electric shock. The 

conductor with insulation having an 

outer surface that is green with or 

without yellow stripes is the equip-

ment-grounding conductor. If repair 

or replacement of the electric cord or 

plug is necessary, do not connect the 

equipment-grounding conductor to a 

live terminal.

Check with a qualified electrician or 

4. 

service personnel if the grounding 

instructions are not completely under-

stood, or if in doubt as to whether the 

tool is properly grounded.
Use only 3-wire extension cords that 

5. 

have 3-prong grounding plugs and 

3-pole receptacles that accept the 

tool’s plug.
Repair or replace damaged or worn 

6. 

cord immediately.

125 V~ 3-prong plug and outlet

(for up to 125 V~ and up to 15 a)

grounding 

pin

This tool is intended for use on a cir-

7. 

cuit that has an outlet that looks like 

the one illustrated above in 

125 V~ 

3-prong plug and outlet

.  The tool 

has a grounding plug that looks like 

the plug illustrated above in 

125 V~ 

3-prong plug and outlet

.

The outlet must be properly installed 

8. 

and grounded in accordance with all 

codes and ordinances.