SKU 38648
For technical questions, please call 1-800-444-3353.
Page 3
replacement parts and ac-
11.
cessories.
When servicing, use
only identical replacement parts.
Only use accessories intended for
use with this product. Approved ac-
cessories are available from Harbor
Freight Tools.
maintain tHis product WitH
12.
care.
Keep this tool clean and
dry, and keep saw blades clean and
sharp for better and safer perfor-
mance.
maintenance:
13.
For your safety,
service and maintenance should be
performed regularly by a qualified
technician.
use tHe rigHt product For
14.
tHe rigHt joB.
There are certain
applications for which this product
was designed. Do not use small
equipment, tools or attachments to
do the work of larger industrial equip-
ment, tools or attachments. Do not
use this product for a purpose for
which it was not intended.
speciFic product Warnings
and precautions
ground tHis product.
1.
The
electrical power cord for this tool is
equipped with a grounded 3-prong
plug. Never remove the grounding
prong or modify the plug in any way.
Do not use adapter plugs with this
product. When in use, make sure
this product is always plugged into a
grounded 3-hole electrical receptacle
with an appropriate breaker switch
in-line.
maKe sure tHe poWer sWitcH
2.
is in tHe “oFF” position Be-
Fore plugging in tHe poWer
cord.
do not aBuse tHe poWer
3.
cord.
Do not use the cord to pull
the 3-prong plug from a power outlet.
Keep cord away from heat, oil, sharp
edges, and moving parts. Replace
damaged cord immediately. Route
the power cord safely. Protect it from
being damaged by other equipment
in the shop. Do not route the cord
where it can be walked on or tripped
over.
recommended minimum Wire
gauge For eXtension cords*
(120/240 Volt)
nameplate
amperes
(at full load)
eXtension cord
lengtH
25’
50’
75’
100’
150’
0 – 2.0
18
18
18
18
16
2.1 – 3.4
18
18
18
16
14
3.5 – 5.0
18
18
16
14
12
5.1 – 7.0
18
16
14
12
12
7.1 – 12.0
18
14
12
10
-
12.1 – 16.0
14
12
10
-
-
16.1 – 20.0
12
10
-
-
-
taBle a
* Based on limiting the line
voltage drop to five volts at
150% of the rated amperes.
iF You use an eXtension
4.
cord, maKe sure to use onlY
ul approVed cords HaV-
ing tHe correct gauge and
lengtH.
(see taBle a.)
maintain a saFe WorK enVi-
5.
ronment.
Do not use this tool in
or near damp or wet areas. Do not
expose this tool to rain. Keep work
area well lit. Make sure there is ad-
equate surrounding work space. Use
