Chicago Electric 41213, Set Up And Operating Instructions Manual

Page 13

SKU 41213

For technical questions, please call 1-800-444-3353.

controls

Polishing

Place a clean Polishing Bonnet (4) securely onto the Backing Pad (4). Tie it 

securely using the drawstring. Make sure to tuck any excess string inside the 

Bonnet

           note: 

Prior to waxing or polishing a vehicle, make sure it’s surface has been 

thoroughly washed, and is free of dust, dirt, oil, grease, etc.
Apply about two tablespoons of wax (not included) evenly on the Polishing Bon-

net (4). Do not apply the wax directly to the surface of the vehicle. The amount 

of wax needed will vary according to the size of the vehicle being waxed.

iMPortant

Carefully inspect the condition of the accessory before use and check the accessory 

continually during use.  If any damage is noted, stop immediately and replace the accessory 

with an undamaged one.  

harbor Freight tools cannot be held responsible for damage 

caused by using a damaged accessory on this tool.

           note: 

Avoid using too much wax. For additional applications of wax to the Polish-

ing Bonnet (4), reduce the amount of wax. The Polishing Bonnet (4) will not 

absorb as much wax in subsequent applications.

Plug the Power Cord (33) into an electrical extension cord (not included). Then, 

plug the extension cord into a grounded, GFCI, 120 volt, electrical outlet.

           note:

 Always start and stop the Polisher while it is held firmly against the surface 

of the vehicle. Failure to do so may result in the Bonnet being thrown from the 

Backing Pad (4). 

1.

2.

3.

Carefully  inspect  the  condition  of  the  accessory  before  use  and  check  the 

accessory continually during use.  If any damage is noted, stop immediately 

and replace the accessory with an undamaged one.

  harbor Freight tools 

cannot  be  held  responsible  for  damage  caused  by  using  a  damaged 

accessory on this tool.

Warning

ON/OFF Switch (24)

oPErating instrUctions