Page 9
SKU 42864
For technical questions, please call 1-800-444-3353.
ASSEmbly INStRuctIONS
Note:
For additional information regarding the parts listed in the following pages, refer to
the
Assembly Diagram
at the end of this manual
.
cAutION:
Always make sure the Power Cord (17) of the Sander is unplugged from its
electrical outlet
prior
to making any adjustments or assembling to the tool.
Attaching the dust collection chute (0)
Turn the Chute (0) so that the tab on top of the rectangular end faces up. Snap it
in place into the rectangular shaft at the back of the Sander.
Connect a 1-1/4” dust collection hose from the Chute to your dust collection system
(hose and system not included).
The Dust Collection Chute (0) will only work if the sandpaper has holes that line up
with the 6 dust collection holes in the Backing Pad (28). (There are 4 other holes in
the Backing Pad for the Screws (29).)
Attaching sandpaper to the backing pad (28)
Press the tab on the Clamps (6) inward
on both sides of the unit and swing
the clamps on both sides up, out, and
down. See
1 & 2
, right.
Cut the sandpaper to fit the 3-1/2” W
x 7-3/8” L Sander Pad (28), with a
little extra to overlap and fit under the
Clamps (6).
Do not use torn or frayed
sandpaper.
After wrapping the overlapped edges of sandpaper under the Clamps (6), snap the
Clamps (6) back into place.
1.
2.
3.
1.
2.
3.
Sandpaper
goes under
here
Sandpaper
goes under
here
