Chicago Electric 44006, Set Up And Operating Instructions Manual

SKU 44006 

For technical questions, please call 1-800-444-3353. 

Page 5

MOUNTING

Note:

  Before use, attach your hoist to 

an overhead pipe using the included 

brackets as follows:

1.  Find the 2 Fixing Rings (#3) and the 

Hex Head Bolts  (#4).

2. 

Figure 1. Mounting the Hoist.

Place the Fixing Rings over a suitable 

pipe, in the position you wish to 

mount the hoist.

3.  Have an assistant hold the hoist 

in place while you install the Bolts 

through the Fixing Rings into the 

threaded holes in the Fixing Rack (#1) 

of the hoist.

4.  With the hoist in the correct position, 

firmly tighten the bolts.

Figure 2. Optional Pole Mount.

Note:

  Your hoist may be mounted on a 

fixed overhead pipe, or attached to a 

pole on a rotating pillar.

OPERATION

1.  The cable spool  will not turn freely. 

To pull out or wind up cable, you must 

operate the power switch.

2.  To operate the power switch, take the 

Handle Base in your hand. Press the 

upper part of the rocker Switch to reel 

in the cable. Press the lower part of 

the rocker cable to reel out cable.

3.  Check to be sure it is safe to lift or 

pull the item. 

4.  To pull out the cable, grasp the lift 

hook, and pull it away from the hoist 

while pressing the lower part of the 

power Switch .  Always leave at least 

three turns of cable on the spool to 

prevent pulling the cable out of the 

Hoist.

5.  Attach the cable firmly to the item 

using the lift hook or pulley lift hook. 

Never wrap the cable around the 

object and hook onto the cable itself. 

This can cause damage to the ob-

REV 02a