SKU 47606
For technical questions, please call 1-800-444-3353.
Page 5
Assembly
Refer to Figure 1.
1. Fit the
Handle band (508)
over the front of the housing above the Bit Sleeve and screw
the
Handle (506)
clockwise to secure. At this point do not fully tighten.
2. Rotate the
Handle (506)
around the tool until it rests on a flat spot on the housing, on the
side you prefer.
note:
The
Drill Stop (504)
is used as a guide when doing repetitive drilling (not chiseling) at
the same depth.
3. With the
Handle (505)
still loose, insert the
Drill Stop (504)
into the hole at the Handle
base. Fully tighten the
Handle (505)
clockwise. If you wish to reposition the
Handle (505)
or the
Drill Stop (504)
, loosen the
Handle (505)
by turning it counterclockwise.
FiguRE 1
Handle (505)
Drill Stop (504)
Bit Sleeve
Handle Band (508)
REV 07j