Page 15
For technical questions, please call 1-888-866-5797.
Item 60373
Note:
The Outer Flange has a step for improved
stability with thick accessories. Keep this step
on the inside for thick accessories. To allow
proper clamping for thin accessories, flip Outer
Flange so this step is on the outside.
6. Thread the Outer Flange onto the Spindle. Wrench
tighten only enough so that the wheel is securely
held on the spindle.
WARNING: To prevent serious injury, do
not overtighten flange. Overtightening can
damage the wheel, causing wheel failure.
Installing a Threaded Accessory
TO PREVENT INJURY: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1. The accessory MUST be:
• rated to at least 11,000 RPM.
• no larger than 4" in diameter.
•
fitted with a threaded opening of 5/8″ x 11 TPI.
• undamaged.
• a sanding disc and backing pad, a
sanding flap disc, a wire wheel or a wire
cup brush (accessories not included).
2. Press in and hold the Lock Pin (21) to
prevent the Spindle (6) from turning.
3. Remove the Outer Flange (1) and the Inner
Flange (2) and keep in a safe place.
4. Thread disc accessory firmly onto the
Spindle. Wrench tighten onto the Spindle.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
6. Before beginning work, provide for sparks
and debris that will fly off the work surface.
General Operating Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Make sure that the Switch is not
locked on, then plug in the tool.
2. Push the switch forward to start the tool.
3. Allow the tool to come up to full speed
before touching the work material.
4. Apply the wheel to the work material at a 10° – 15°
angle, allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
5. To create a smoother surface,
keep the tool moving over the work surface.
NOTICE:
TO PREVENT TOOL DAMAGE:
Only use the tool for 15-20 minutes at a time.
Allow the tool to cool completely before next use.
6. Pull the switch backward to stop the tool.
7. Allow the tool to come to a complete
stop before setting it down.
8. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
