Page 10
For technical questions, please call 1-888-866-5797.
Item 61737
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
General Operating instructions
tO prEVEnt SEriOuS inJury:
Wear anSi-approved safety goggles and heavy-duty work gloves during use.
1.
BEFOrE EacH uSE, lubricate the Shears:
a.
Make sure that the power Switch is in the
OFF position, then plug in the Shears.
b.
turn on the Shears and run for one minute.
c.
turn off the Shears, then unplug from outlet.
d.
put 3-4 drops of light machine
oil in the Oil port.
e.
turn the tool on its side, and put 1-2 drops
of light machine oil above the upper Blade.
area above
upper
Blade
Oil
port
Figure D
2. Make a few practice cuts on scrap material
before cutting your workpiece.
3. Make sure that the Power Switch is in the
OFF position, then plug in the Shears.
4. Turn on the Shears.
note:
To prevent damage to the blades,
do not cut across a welded seam.
5. To cut material, fit the Guide over the edge
of the material, and move the tool slowly
forward along the desired cut line.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
